Use rinse-free liquid shampoo and towel it out
When shower or basin access is difficult, a towel-removal liquid can offer a seated washing option. You still need to reach all your hair and remove the solution thoroughly.
Step by step
STEP 1 OF 4Arrange a seated wash
- Check the liquid’s starting state, amount, removal directions and warnings. Put a clean towel and the bottle on a reachable table.
- Sit upright with a towel over your shoulders. Open the bottle with clean hands; keep clean water available for accidental eye contact.
STEP 2 OF 4Wet your hair with the liquid
- Starting on dry hair, use the bottle as directed to wet the areas the label names. Work in manageable sections and control drips.
- Set the bottle down before moving hair aside. Continue around the sides and back until you have covered all the required areas.
STEP 3 OF 4Distribute gently with your hands
- Put the bottle down. With finger pads, gently work the solution through the scalp and hair as the label directs.
- Reach the crown, sides and nape without scratching. Keep loose lengths down; pause if you cannot reach an area comfortably.
STEP 4 OF 4Remove the solution with a towel
- Press and lift a clean absorbent towel across every treated area. Use dry parts of the towel to remove as much moisture as directed.
- Do not leave the wet solution to evaporate instead of towel-removing it. Let remaining dampness air dry after towel removal.
- Close the bottle, put the used towels aside to wash, and clean any drips from the table and floor.
Includes setup, full application, distribution, towel removal and cleanup; complete air drying is separate.
You’re done when…
All treated areas have been thoroughly towel-dried as directed, with no dripping liquid. Remaining dampness can air dry.

