Skip to main content

Set curls with flexi rods

Choose flexi rods when you want a spiral no-heat setting pattern with a fastener built into each bendable rod. The wrap and bend differ from a conventional roller set.

A woman uses both hands to spiral one damp section smoothly along a straight flexi rod.

Step by step

  1. A woman with damp coily shoulder-length hair holds one flexi rod beside a separated side section.
    STEP 1 OF 4

    Prepare reachable sections

    • Start with damp, detangled loose hair and choose rods the hair can wrap around smoothly.
    • Clip most hair aside and bring one section forward where both hands can reach it.
  2. A woman uses both hands to spiral one damp section smoothly along a straight flexi rod.
    STEP 2 OF 4

    Wrap the section

    • Lay the tips smoothly over one end of the rod and hold them with your fingertips.
    • Turn the rod so the rest of the section spirals along it without crossing over itself.
  3. A woman supports a wrapped flexi rod at the side of her head while bending its ends inward to secure it.
    STEP 3 OF 4

    Bend the rod to hold

    • Stop before the root feels tight, then bend one rod end inward.
    • Support the wrap while bending the other end; keep nearby loose hair out of the folds.
    • Repeat the prepare, wrap and bend steps until every intended section is on a comfortable rod.
  4. A woman straightens and unwinds one flexi rod from a fully dry spiral while the remaining rods stay in place.
    STEP 4 OF 4

    Dry and unwind

    • Wait until the root and inner wraps are dry, checking one rod before taking down the rest.
    • Straighten the rod ends, support the section and reverse the wrap without pulling the rod through it.
    • After all rods are out, arrange the dry curls lightly with your fingers and collect every rod and sectioning clip.

About 30–75 min hands-on for dividing, wrapping a full flexi-rod set, securing and later unwinding it. Start with damp, detangled hair. Add complete drying and breaks.

Practical editorial estimate, not measured. Many small rods require repeated smoothing, wrapping and release; dense or long hair and first attempts can take longer.

You’re done when…

All rods are straightened and removed without snagging, and each section was dry at the root and through the wrap before release.