Skip to main content

Put on and remove a glueless wig

Put on a fitted removable wig without glue, adjust it using the cap’s sturdy edges and check that it feels comfortable. Release any built-in clips before lifting it off.

Step by step

  1. A man holds a short curly wig by its sturdy cap before putting it on.
    STEP 1 OF 6

    Check the cap before putting it on

    • Start with a dry wig that has already been fitted for glueless wear. Check the cap, straps and fasteners for damage.
    • Set adjustable straps while the wig is off your head. Identify the front, nape, ear tabs and any clips using its fitting instructions.
    • If you have hair, arrange it loosely and evenly underneath. Use a liner only if needed and compatible with this wig.
  2. A man holds the wig’s sturdy nape edges as he guides the cap over his head.
    STEP 2 OF 6

    Guide the cap over your head

    • Hold the sturdy nape edges with both hands, with the opening facing you. Keep your fingers away from delicate lace.
    • Set the front near its intended hairline, then guide the cap back over your head. Keep your ears outside the cap.
  3. A man adjusts a removable short curly wig by the ear tabs with both hands.
    STEP 3 OF 6

    Adjust with the ear tabs

    • Use the small tabs just in front of your ears to make gentle, even adjustments. Follow the wig’s intended front position.
    • Keep fingers out from under the lace and do not stretch it. Secure any built-in fasteners using the wig’s instructions.
  4. The man turns his head gently with both hands lowered after placing the wig.
    STEP 4 OF 6

    Lower your hands and check the fit

    • Turn your head gently with your hands lowered. Check the front, ears and nape for pinching or pulling.
    • If it slips or presses, remove it and check for bunched hair, a folded liner or a fit problem. Ask the supplier if adjusting the setup does not help.
  5. A wearer supports the cap beside a built-in clip while opening the clip and freeing her own hair.
    STEP 5 OF 6

    Release any built-in clips

    • Before lifting the wig, support the cap beside each built-in clip. For a snap-comb clip, hold its ends and gently press the middle to pop it open.
    • Free caught hair and check that every clip has released. Follow the wig’s instructions for other fasteners; if it has no hair clips, skip this step.

    This photo shows a different wig with a built-in hair clip. The main demonstration wig has no hair clips.

  6. A man lifts the removable wig clear by its cap sides.
    STEP 6 OF 6

    Lift off by the sturdy cap sides

    • Hold the sturdy sides with both hands and lift the wig clear. Stop and free any caught hair instead of pulling.
    • Set it on its suitable stand or clean storage surface. Remove any liner or grip separately and put loose accessories away.

One application and later removal; washing, hair preparation and fitting a new wig are separate.

Editorial estimate, not timed. Familiarity with the fasteners and the time needed for careful handling can change the hands-on work.

You’re done when…

The cap sits evenly with ears free and no pinching or pulling. For removal, all fasteners release before the cap lifts clear.