Tie and remove a durag

Step by step

1. 

   STEP 1 OF 3

   Center the panel over dry hair

   • Begin with dry short hair and a clean durag. Identify the front, center seam and rear flap from its directions.
   • Set its front above your eyebrows with the center seam aligned down the middle. Let the rear flap lie down the back and one strap hang at each side.
   • Smooth loose folds with your hands without rubbing or pulling the hair. Keep your face and ears clear.
2. 

   STEP 2 OF 3

   Cross flat straps and tie a bow

   • Hold one strap in each hand. Take them behind your head and cross them, then bring each end forward above the ears.
   • Keep the straps spread flat rather than rolled into narrow cords. Tie the ends in an easy-to-release bow at the front without pulling the panel tight.
   • Lower your hands and turn your head. Loosen or remove the durag if you feel pressure or pulling; do not tighten it to chase wave definition.
3. 

   STEP 3 OF 3

   Untie before lifting away

   • Hold the bow and gently draw out a free end to open it. Unwrap each strap around the sides and undo the rear crossing.
   • With both straps free, lift the panel away using both hands. Ease any caught hair out before continuing.
   • Let the hair settle. Clean and dry the durag by its care label before storage when needed.